HP StorageWorks 2500 Disk System Enclosure User Manual Page 29

  • Download
  • Add to my manuals
  • Print
  • Page
    / 89
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 28
1
2
CXO8197A
Figure 14 Disengaging the shipping bracket
Reducing the enclosure weight
Before you install a DS2500, reduce its weight by removing the drive blanks, power supply/blower
assemblies, EMU, and I/O modules. The removal procedures in this section do not apply to an
operating enclosure, as they assume that there are no cables attached to the components, and no
power is co
nnected.
WARNING!
A DS2500 with all components installed weighs more than 29.5 kg (65 lb) and requires a minimum of
two people to move. To safely and easily install the DS2500, remove the components as described in
this section. This reduces the DS2500 weight to approximately 11.0 kg (24 lb).
CAUTION:
Parts can be damaged by electrostatic discharge. Use proper antistatic protection as described in the
documentation that shipped with your system.
Removing the drive blanks
To remove
a drive blank:
1. Grasp the drive blank by the two tabs (Figure 15).
2. Lift up on the bottom tab and pull the blank out of the enclosure.
2500 Disk System user guide
29
Page view 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 88 89

Comments to this Manuals

No comments