HP ProCurve 9315M User Manual download pdf (Page 36)

Release Notes for 07.8.04 Software Fixes

43721 After you install a 2-port 1-Gigabit Ethernet module,

the dm delete <slot-number> command causes the

routing switch to reload.

10GE link 07.6.05 07.8.01c

44138 CPU spikes occur for about 8 seconds when you

add or remove ports with an outbound ACL on a

VLAN.

CPU, ACL 07.6.06 07.8.01c

45057 The show cpu command displays 1% CPU

utilization even though there are a very large

number of packets transmitted through the CPU.

CPU 07.8.00 07.8.01c

47395 If the primary link in an LACP 802.3ad trunk goes

down for more than 90 seconds, then comes back

up, port flapping occurs.

LACP 07.8.00 07.8.01c

47584 When you add a MAC address in a trunk group, a

data access exception may occur in the

“ipc_r_read” routine.

Trunk Group 07.6.06 07.8.01c

47825 RIP redistribution does not update the OSPF

forwarding address field when RIP is updated.

RIP, OSPF 07.6.06 07.8.01c

48859 BGP router A redistributes a tagged BGP route as

an OSPF link-state advertisement (LSA) to router B

running OSPF. Router B sends the OSPF LSA to

router C. If BGP router A changes the tag, router

C’s OSPF database is updated, but not the OSPF

route.

BGP, OSPF 07.6.06 07.8.01c

49240 If you disconnect a 10 Gigabit Ethernet port when a

large number of modules are installed in a switch,

packet loss may result in a 10GE link for three to

five seconds.

10GE link 07.6.04 07.8.01c

49319 After you enter the no ip forward route command,

OSPF cannot add a route from link-state (LS)

database.

OSPF 07.6.00 07.8.01c

49731 The trunk threshold command does not take effect

until you reload the routing switch. Also, when you

remove a trunk and re-create a new trunk, the

existing threshold value is applied to the newly

created trunk.

Trunk Group 07.8.1 07.8.01c

49914 When you change the router ID (by modifying the IP

address of loopback), OSPF stops advertising the

default route. This problem is not detected when the

the default-information-originate value is

configured.

OSPF 07.8.00 07.8.01c

50203 The routing switch does not flash a MAC address

when the MRP topology changes, even if the

routing switch receives a topology change packet.

MRP 07.8.00 07.8.01c

50541 Network latency jumps from sub-millisecond to

300+ milliseconds when MAC filters are applied.

MAC filters 07.8.01 07.8.01c

Bug ID Bug Description Protocol/

Feature

Version

Found

Version

Fixed

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 65 66

Comments to this Manuals

No comments

HP ProCurve 9315M User Manual Page 36

Comments to this Manuals

Related products and manuals for Network switch modules HP ProCurve 9315M