HP TippingPoint Next Generation Firewall Series Installation Manual download pdf (Page 42)

30 Connector and Cable Pinout Specifications

NOTE: These ports can auto-negotiate their mode and can automatically detect whether they should

operate in straight-through or cross-over mode.

Use the following pinout information when your RJ-45 device is operating in 1000Mbps (1GbE) mode.

Pluggable Transceivers

The NGFW S3000 Series and S8000 Series Appliances can also have pluggable transceivers. The

following SFP transceivers are supported on both S3000 Series and S8000 Series models. The following

SFP+ transceivers (with HP names) are supported on S8000 Series models:

• HP X126 1G SFP RJ45 T (Copper SFP)

• HP X126 1G SFP LC LX 10km 1310nm XCVR

• HP X126 1G SFP LC SX 550m 850nm XCVR

• HP S136 10G SFP+ LC SR

• HP S136 10G SFP+ LC LR

NOTE: Only optical transceiver modules (including SFP and SFP+) available from HP TippingPoint have

been validated to achieve optimal performance with HP TippingPoint products. Other vendor devices are

not supported. Using other vendor devices could be detrimental to proper operation of the HP TippingPoint

system.

The following table details the information for SFP and SFP+ transceivers.

7Ground (GND)

8Ground (GND)

Table A-3 RJ-45 Connector Pinouts for 1GbE Mode

Pin Number Signal Name

1 Twisted Pair 1 positive (TP1+)

2 Twisted Pair 1 negative (TP1-)

3 Twisted Pair 2 positive (TP2+)

4 Twisted Pair 3 positive (TP3+)

5 Twisted Pair 3 negative (TP3-)

6 Twisted Pair 2 negative (TP2-)

7 Twisted Pair 4 positive (TP4+)

8 Twisted Pair 4 negative (TP4-)

Table A-2 RJ-45 Ethernet Connector Pinouts

Pin Number Signal Name

Fiber Input Signal

Left side Transmit

Right side Receive

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 53 54

No comments

HP TippingPoint Next Generation Firewall Series Installation Manual Page 42