Next Generation Firewall Hardware Specification and Installation Guide 29
A Connector and Cable Pinout Specifications
This information provides connector and pinout information for the NGFW Appliance and contains the
following topics:
•”RJ-45 (COM) Console” on page 29
•”RJ-45 Ethernet Connectors” on page 29
•”Pluggable Transceivers” on page 30
RJ-45 (COM) Console
The following figure displays the RJ-45 connector and Table A-1 shows the RJ-45 console connector
pinouts.
Figure A-1 RJ-45 Connector
RJ-45 Ethernet Connectors
Use the following pinout information when your RJ-45 device is operating in 10Mbps/100Mbps mode.
Table A-1 RJ-45 Console Connector Pinouts
Pin Number Signal Name
1Request to Send (RTS)
2 Data Terminal Ready (DTR)
3 Transmit Data (TxD)
4Ground (GND)
5 Ground (GND)
6 Receive Data (RxD)
7 Data Set Ready (DSR)
8 Clear to Send (CTS)
Table A-2 RJ-45 Ethernet Connector Pinouts
Pin Number Signal Name
1 Transmit positive (Tx+)
2 Transmit negative (Tx-)
3 Receive positive (Rx+)
4Ground (GND)
5Ground (GND)
6Receive negative (Rx-)
Comments to this Manuals