HP 14-3100eb SPECTRE Technical Information download pdf (Page 63)

Fan

Description Spare part number

Fan (includes cable) 672008-001

NOTE: To properly ventilate the computer, allow at least 7.6 cm (3 in) of clearance on the left side of

the computer. The computer uses an electric fan for ventilation. The fan is controlled by a temperature

sensor and is designed to turn on automatically when high temperature conditions exist. These

conditions are affected by high external temperatures, system power consumption, power

management/battery conservation configurations, battery fast charging, and software requirements.

Exhaust air is displaced through the ventilation grill located on the left side of the computer.

Before removing either of the fans, follow these steps:

1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn

the computer on, and then shut it down through the operating system.

2. Disconnect the power from the computer by unplugging the power cord from the computer.

3. Disconnect all external devices from the computer.

4. Remove the battery (see

Battery on page 33), and then remove the following components:

a. Solid-state drive connector board cable (see

Solid-state drive on page 35)

Card Reader board cable (see

Card Reader board cable on page 37)

c. Top cover (see

Top cover on page 40)

Remove the fan:

NOTE: The right fan must be removed before the left fan.

1. Disconnect the fan cable (1) from the system board.

2. Lift the rear edge of the fan (2) until the tape (3) attaching the fan to the heat sink detaches.

Component replacement procedures

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 97 98

No comments

HP 14-3100eb SPECTRE Technical Information Page 63