HP DESKJET D730 User Manual download pdf (Page 98)

The printout has a horizontal band of distortion near the bottom of a borderless

Try the following solutions if your borderless print has a blurry band or line on the bottom

of it.

NOTE: For this issue, there is not a problem with your ink supplies. Therefore,

replacing the print cartridges is not necessary.

• Solution 1: Check the paper type

•

Solution 2: Check the print quality setting

•

Solution 3: Rotate the image

Solution 1: Check the paper type

Solution: HP recommends that you use HP Advanced Papers or any other paper

type that is appropriate for the product.

Always make sure the paper you are printing on is flat. For best results when printing

images, use HP Advanced Photo Paper.

For more information, see:

Store and handle photo paper

Cause: The wrong kind of paper was loaded in the input tray.

If this did not solve the issue, try the next solution.

Solution 2: Check the print quality setting

Solution: Check the quality setting. Use a higher quality setting to increase the

amount of ink used for printing.

For more information, see:

•

Change the print speed or quality

•

Maximum dpi

Cause: The print quality setting was set to low.

If this did not solve the issue, try the next solution.

Solution 3: Rotate the image

Solution: If the problem persists, use the software you installed with the product or

another software application to rotate your image 180 degrees so that the light blue,

gray, or brown hues in your image do not print at the bottom of the page.

Cause: The photo image had light blue, gray, or brown hues that print near the

bottom of the page.

Chapter 11

96 Troubleshooting

Troubleshooting

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 121 122

No comments

HP DESKJET D730 User Manual Page 98