HP Officejet LH 6000 User Manual download pdf (Page 59)

Chapter 4 Diagnostics

4. If the problem persists put your memory module in another socket. If the error code changes

and indicates the new location of the memory module, it needs to be replaced. Contact your

service representative.

5. To allow the HP NetServer to start with the remaining available memory, remove the defective

module and change the memory size in the Setup utility.

0800 The cache memory size detected during the power-on self-test is smaller than previously detected. The

cache memory module is either disconnected, defective or has been replaced by a smaller one.

1. If the cache memory module has just been removed or replaced by a smaller one, press [F4] to

automatically validate the change.

2. If the cache memory module has not been removed or changed, ensure it is properly inserted in

its socket.

3. If the problem persists, the cache memory module may need to be replaced. Contact your

service representative.

0801 The cache memory module has reported an error during its self-test.

1. Remove the cache memory module from its socket and clean the edge connector. Refer to your

HP NetServer Installation Guide for handling precautions.

2. Re-install the cache memory module.

3. If the problem persists, your cache memory module may need to be replaced. Contact your

service representative and specify the error code.

0900 The integrated LAN interface has reported an error during its self-test.

1. Check that the LAN interface is properly inserted in its slot.

2. Check that the COAX module is correctly installed (if present).

3. Check that all the cables are firmly connected.

4. If the problem persists, your LAN adapter may need to be replaced. Contact your service

representative.

0901 The integrated LAN interface is not responding.

1. If the integrated LAN interface has just been removed, press [F4] to automatically validate the

change.

2. Check that the LAN interface is properly inserted in its slot.

3. Check that all cables and power cords are firmly connected.

4. If the problem persists, your LAN adapter may need to be replaced. Contact your service

representative.

0B0X Your system is missing the Microcode Update data block for the Pentium III microprocessor.

You must correct this problem in order to avoid possible malfunction or reliability problems.

To correct the problem, update your BIOS by running the flash utility from your HP NetServer Navigator CD-

ROM. To do this, insert the HP NetServer Navigator CD-ROM in the CD-ROM drive and power-cycle your

system. See BIOS Recovery.

If updating your BIOS does not clear this error, contact your service representative.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 113 114

No comments

HP Officejet LH 6000 User Manual Page 59