HP Officejet LH 6000 User Manual download pdf (Page 97)

Chapter 6 Replacing Parts

Removing the Power Supply Fan Assembly

Install the new fan assembly by using the above procedures in reverse.

Replacing the Rear Chassis Fans

The rear chassis fans are individually mounted just to the rear of the system board assembly. These fans are

individually replaceable and may be hot-swapped.

CAUTION Do not run this NetServer for more than 60 minutes without all covers in place. Any

component being replaced must be removed and a replacement installed within this

60-minute time window. If you feel that you cannot, in your estimate, replace any

particular component within this time, first turn off power to the system and then

replace the component. Failure to replace the covers within 60 minutes may result in

damage to system components due to lack of cooling air.

Follow these instructions to remove and replace the chassis fans:

1. Back up the hard disk drive(s) and save the configuration.

2. If necessary, shutdown the network operating system.

3. Turn off the HP NetServer and display.

4. Disconnect all telephone cables and power cords.

5. Remove the side cover.

6. Remove the individual fan assembly by pressing the handles and pulling the assembly out of

the chassis.

Removing a Rear Chassis Fan

Install the new fan assembly by using the above procedures in reverse.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 113 114

No comments

HP Officejet LH 6000 User Manual Page 97