Hp LaserJet 9000 Printer series User Manual Page 159

  • Download
  • Add to my manuals
  • Print
  • Page
    / 250
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 158
Chapter 5 Problem solving 159
Checking the printer configuration
1 Product Name and Printer Name indicate the series of HP LaserJet printer in use.
2Usage Totals indicates types of pages that have been printed, the number of single-sided pages printed,
the number of duplexed pages printed, and the total number of pages printed.
3 Coverage indicates the amount of toner used on a page.
PCL or PS font list
Use the font lists to see which fonts are currently installed in the printer. (The font lists also show which fonts
are resident on a hard disk or flash DIMM.)
The PS font list shows the PS fonts installed, and gives a sample of those fonts. The following describes the
information that can be found on the PCL font list:
z Font gives the font names and samples.
z Pitch/Point indicates the pitch and point size of the font.
z Escape Sequence (a PCL 5e programming command) is used to select the designated font. (See the
legend at the bottom of the font list page.)
Note For step-by-step instructions about using printer commands to select a font with MS-DOS programs,
see Common PCL 5e printer commands on page 212.
z Font # is the number used to select fonts from the printer control panel (not the software application). Do
not confuse the font # with the font ID, described below. The number indicates the DIMM slot where the
font is stored.
SOFT: Downloaded fonts that stay resident in the printer until other fonts are downloaded to replace
them or until the printer is turned off.
INTERNAL: Fonts that permanently reside in the printer.
z Font ID is the number you assign to soft fonts when you download them through software.
Page view 158
1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 249 250

Comments to this Manuals

No comments