HP 300i Service Manual download pdf (Page 102)

The Printer Drive Assembly

5-12

Replacing the Printer Drive Assembly

To replace the printer drive assembly:

• If necessary, reinstall the gears. The gears are arranged on the shafts in the gear housing

as shown in Figure 5-6. Each gear has a number molded into it. That number corre-

sponds to a number molded into the gear housing next to the appropriate shaft. Insert

gears with molded numbers facing up.

• Pay special attention to gear #1. The top of the gear has a short lip molded close to the

teeth. The bottom of the gear has a taller lip molded next to the hole for the shaft. Make

sure the short lip and molded number face up.

Figure 5-6 The Printer Drive Gears.

A. Gear #1

• Perform the removal procedure in reverse order.

Make sure none of the printer cables are pinched between the printer drive assembly and

the top cover.

NOTE

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 163 164

No comments

HP 300i Service Manual Page 102