HP STORAGEWORKS e1200-160 User Manual download pdf (Page 61)

Visual Manager User Interface

61Network Storage Router e1200-160

Caution: If this configuration setting is incorrectly set, processing difficulties

may occur. Before changing this setting, evaluate the need for the change

and verify the desired setting. HP recommends backing up the router

configuration to an external file before making changes to this setting.

Note: Target IDs must be setup before mapping devices on the SCSI bus.

Note: Do not enable Target IDs unless there is a SCSI initiator on the bus that wants to

use Fibre Channel devices. This type of configuration is known as a Target Mode

configuration.

■ Discovery toggles between Enabled and Disabled.

■ Discovery Delay is the wait time after a power-up or reboot before

discovering SCSI devices.

Note: HP recommends setting the value to at least 30 seconds to ensure all SCSI

devices complete their individual power-ups.

■ Bus Reset on Boot toggles between Enabled and Disabled.

When enabled, the router will automatically reset SCSI buses during a power

up or reboot of the router.

■ Internal Termination toggles between Enabled and Disabled.

Caution: If this configuration setting is incorrectly set, processing difficulties

may occur. Before changing this setting, evaluate the need for the change

and verify the desired setting. HP recommends backing up the router

configuration to an external file before making changes to this setting.

When enabled, internal termination of the selected SCSI bus is allowed.

When disabled, the SCSI Bus, not the router handles SCSI termination.

■ Buffered Tape Writes (default: Enabled) toggles between Enabled and

Disabled.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 199 200

No comments

HP STORAGEWORKS e1200-160 User Manual Page 61