HP STORAGEWORKS e1200-160 User Manual download pdf (Page 107)

Serial/Telnet User Interface

107Network Storage Router e1200-160

Note: This value should be set to no less than 250ms, according to the SCSI standard

for Reset-to-Selection Time. HP recommends setting the value to at least 30 seconds to

ensure all SCSI devices complete their individual POST.

■ 5) Set SCSI Termination Mode enables or disables the SCSI termination

mode.

■ 6) Edit SCSI Target Override Settings changes the SCSI Target overrides.

SCSI Parameter Override Configuration Menu options:

— 1) Toggle CDB Length Override: enabled or disabled.

If enabled, the following configuration options are displayed:

CDB Group 6 Length Default (default = 0) can be set to 0, 6, 10, or 12.

CDB Group 7 Length Default (default = 0) can be set to 0, 6, 10, or 12.

— 2) Toggle Wide Negotiation: enabled or disabled.

— 3) Toggle Synchronous Negotiation: enabled or disabled.

If enabled, the following configuration options are displayed:

Synchronous Period (default = 40) is the maximum number of seconds

allowed for negotiation.

Synchronous Offset (default =16) is the maximum variation in transfer

rate that can be negotiated in MB/s.

— 4) Toggle Synchronous Parameter Override: enabled or disabled.

■ 7) Enable/Disable Buffered Tape Writes (default: Enabled) enables or

disables Buffered Tape Writes.

Buffered Tape Writes return status on consecutive write commands before the

tape device receives data, to enhance performance.

■ 8) Change Default Map Value sets the default map to use for the bus.

Mapping modes can be Auto-Assigned (default), Indexed, or SCC.

For more information about addressing methods, see Appendix C,

"Addressing Methods and Table Structures."

■ X) Return to previous menu returns to previous menu.

■ Command <Enter> scrolls to the next SCSI bus.

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 199 200

No comments

HP STORAGEWORKS e1200-160 User Manual Page 107