HP STORAGEWORKS e1200-160 User Manual download pdf (Page 49)

Visual Manager User Interface

49Network Storage Router e1200-160

The Ethernet physical address is always assigned by the manufacturer.

■ IP address (default: 1.1.1.1) is the IP address of the router.

■ Subnet Mask (default: 255.255.255.0) is the IP subnet mask for the router.

■ IP Gateway (default: 0.0.0.0) is the IP address of the gateway for the Ethernet

network connected to the router.

■ DHCP enables or disables support for Dynamic Host Configuration Protocol

(DHCP).

When DHCP is enabled, the router requests a dynamic IP address from a

DHCP server on the Ethernet network. The router must be rebooted before an

IP address will be requested from the DHCP server. After the router is

rebooted, the HTTP session must be restarted. The IP address will be different

from the former non-DHCP IP address.

Note: To use the DHCP feature, a DHCP server must be operational on the Ethernet

network. If the DHCP feature is used when there is not DHCP server, the standard for

DHCP requires the router wait thee minutes for a response from a DHCP server before

timing out.

Some DHCP servers allow a lease reservation to be set up for an IP address by

providing the server with the Ethernet MAC address. The DHCP server

always provides the same IP address to the router. This setup can be useful for

remote management of the router via Telnet or VM. Because the method of

setting up a lease reservation varies, depending on the DHCP server being

used contact the Network Administrator for assistance.

SNMP Configuration

SNMP configuration is not supported.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 199 200

No comments

HP STORAGEWORKS e1200-160 User Manual Page 49