HP STORAGEWORKS e1200-160 User Manual download pdf (Page 100)

Serial/Telnet User Interface

100 Network Storage Router e1200-160

■ 7) Toggle DHCP Configuration enables or disables support for Dynamic

Configuration Protocol.

When DHCP is enabled, the router will request a dynamic IP address from the

DHCP server on the Ethernet network.

Some DHCP servers allow a lease reservation to be set up for an IP address by

providing the server with the Ethernet MAC address. The DHCP server will

then always provide the same IP address to the router. This setup can be

useful for remote management of the router such as Telnet or Visual Manager

Because the method of setting up a lease reservation varies depending on the

DHCP server being used, contact your Network Administrator for assistance.

Note: To use the DHCP feature, a DHCP server must be operational on the Ethernet

network. If the DHCP feature is used when there is no DHCP server, DHCP standards

require the router wait three minutes for a response from a DHCP server before timing

out.

■ 8) Change SNMP Settings is not supported.

■ 9) Change Security Settings changes security settings, including the user

name and password.

The default user name is root and the default password is password.

Caution: To ensure security, change the user name and password from the

default settings.

Note: The security settings entered here affect all user interfaces.

User names and passwords should be unique and kept confidential. HP

recommends using a combination of letters and numbers when creating user

names and passwords.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 199 200

No comments

HP STORAGEWORKS e1200-160 User Manual Page 100