HP -PB 10 User Manual download pdf (Page 21)

Chapter 1 21

Installing and Conﬁguring 10/100Base-TX/9000

Step 1: Check the 10/100Base-TX Installation Prerequisites

shown in “Table 1: 10/100Base-TX/9000 Card Summary.”

*The speed conﬁguration of the 10/100Base-TX card is determined by

the speed setting of the hub or switch port to which the card is

connected. The card automatically senses this speed. The card only

runs at one speed at a time. To verify the speed selection, use the

LED indicators on the front of the 10/100Base-TX card as shown

below or run lanadmin and check the link speed and duplex mode at

the LAN Interface Status Display.

6. You have super-user status.

NOTE The only Application Programmatic Interface (API) supported by the

10/100Base-TX /9000 product is the Data Link Provider Interface

(DLPI). Refer to the DLPI Programmer’s Guide for more detailed

information .

Table 1-1 10/100Base-TX/9000 Card Summary

Category 10/100Base-TX

UTP Connection 8-pin RJ45

Speed

10 Mbit/s or 100 Mbit/s

Conﬁgure Speed At hub or switch port

LED on Card Yes

Card Selftest Yes

Half-Duplex Yes

Full-Duplex Yes

Conﬁgure Duplex

Mode

Half-Duplex at hub or

full-duplex at switch.

Autonegotiation Yes

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 111 112

No comments

HP -PB 10 User Manual Page 21