HP 640n User's Guide download pdf (Page 41)

Table 3-2 TFTP configuration file parameters (continued)

slp-keep-alive:

Number of minutes the print server waits between sending multicast packets on the network to prevent deletion from

network device tables. The range is 1 to 1440 minutes. Some infrastructure devices, such as switches, delete active

devices from their device tables because of network inactivity. 0: Disable.

slp-client-mode:

Use the service location protocol (SLP) to locate and install printers on the network. 0 (default): Disable. 1: Enable.

syslog-protocol

Use the TCP or UDP port for syslog communication when logging security events. 6: PROTO_TCP. 17 (default):

PROTO_UDP.

syslog-port

Valid port number of the TCP or UDP port for syslog communication when logging security events. The valid range is

from 1 to 65535. The default port number is 514.

ttl-slp:

IP multicast time to live (TTL) setting for SLP packets. The range is 1 to 15 hops. (A hop is the number of routers from

the local network.). -1: Disable. 4 (default): Enable.

bonjour-config:

Use Bonjour. (Previously listed as multicast domain name system [mDNS services.) Bonjour is typically used for IP

address and name resolution (through UDP port 5353) where a conventional DNS server is neither used or available. 0:

Disable. 1 (default): Enable.

bonjour-svc-name:

Bonjour service name. This name is persistent and is used to resolve a particular device or service if socket information

(such as the IP address) changes from session to session. Apple Bonjour displays this service. The default service

name is the printer model and the LAN hardware (MAC) address. Enter up to 64 alphanumeric characters.

bonjour-domain-na

(Read only.) Bonjour domain name assigned to the device, in the form <host name>.local. If a user-specified host name

is not assigned, the default host name NPIxxxxxx is used, where xxxxxx are the last 6 digits of the LAN hardware

(MAC) address.

bonjour-pri-svc:

Highest priority Bonjour service to use for printing. Set this using the following values:

1: Port 9100 printing

2: IPP port printing

3: Default LPD raw queue

4: Default LPD text queue

5: Default LPD auto queue

6: Default LPD binps (binary PostScript) queue

7 through 12: If user-specified LPD queues are defined, corresponds to user-specified LPD queues 5 through 10.

The default selection depends on the printer, typically port 9100 printing or LPD binps.

ENWW IPv4 configuration 31

1 ... 40 41 42 ... 228

No comments

HP 640n User's Guide Page 41