HP F4210 User Manual Page 102

  • Download
  • Add to my manuals
  • Print
  • Page
    / 220
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 101
Solution 3: Rotate the image
Solution: If the problem persists, use the software you installed with the product or
another software application to rotate your image 180 degrees so that the light blue,
gray, or brown hues in your image do not print at the bottom of the page.
For more information, see:
Change the page orientation” on page 34
Cause: The photo image had light blue, gray, or brown hues that print near the
bottom of the page.
Printouts have horizontal streaks or lines
Try the following solutions if your printout has lines, streaks, or marks on it that run side-
to-side across the width of the page.
Solution 1: Make sure the paper is loaded correctly
Solution 2: Check the print quality setting
Solution 3: If the print cartridge was dropped, wait for it to recover
Solution 4: Clean the print cartridge nozzles
Solution 5: Clean the print cartridges
Solution 1: Make sure the paper is loaded correctly
Solution: Make sure the paper is loaded correctly.
For more information, see:
Load full-size paper” on page 24
Cause: The paper was not feeding properly or was not loaded correctly.
If this did not solve the issue, try the next solution.
Solution 2: Check the print quality setting
Solution: Check the quality setting. Use a higher quality setting to increase the
amount of ink used for printing.
NOTE: For maximum dpi resolution, go to the Advanced tab, and then select
Enabled from the Maximum dpi drop-down list. For more information, see
Print
using Maximum dpi” on page 41.
For more information, see:
•“
Change the print speed or quality” on page 34
•“
Print using Maximum dpi” on page 41
Cause: The print quality setting was set to low.
If this did not solve the issue, try the next solution.
Chapter 12
100 Troubleshooting
Troubleshooting
Page view 101
1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 219 220

Comments to this Manuals

No comments