HP H35000 User Manual download pdf (Page 54)

2-22 Printing Tips

Calibrating the

Moveable Fence

The moveable fence is calibrated at the factory to be parallel to

the top surface of the media, at a height just above the top of the

table rollers (lower than the thickest media that will be used on

the printer).

If the moveable fence needs to be recalibrated, follow this

procedure:

1. Place a piece of rigid media under the pinch rollers, and

align it against the stationary fence.

2. Slide the moveable fence next to the edge of the media and

observe its position relative to the top surface of the media.

3. If the fence is not parallel to the top edge of the media, use a

2.5 mm hex wrench to turn the position screw (shown below)

until the moveable arm is parallel with the media.

Fig. 2-12. Location of position screw

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 123 124

No comments

HP H35000 User Manual Page 54