HP H35000 User Manual download pdf (Page 44)

2-12 Load and Print on Rigid Media

10. Slide the adjustable media fence against the right side of the

media. Then lock it in place.

At this point you can also adjust the speed of the vacuum

fans, or switch them on or off. If the sheet is warped or not

being held down, increase the vacuum fans or raise the

pinch rollers.

11. If the edge of the media you are using is directly below a

pinch roller, raise that pinch roller by pushing it up and then

pushing the latch toward the rail to engage it (see Fig. 2-5

below). To lower the pinch roller, push it up and the latch will

disengage, then lower the roller to the platen.

12. Move the media edge holders (for roll-fed media) out of the

media path, and make sure that the output door is closed.

13. Press the ! (Proceed) key on the control panel, or the

Load/Unload switch on the back of the printer to the Load

position, or the optional foot switch (if installed). This causes

the printer to:

• Measure the media thickness

• Measure the media width

• Find the leading edge of the media

Fig. 2-5. Pinch rollers

Latch

Pinch roller assemblies Media thickness sensor

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 123 124

No comments

HP H35000 User Manual Page 44