HP Net PC 20 Technical Information download pdf (Page 67)

Reverse this procedure to install the speakers.

Optical drive connector cable

NOTE: The optical drive connector cable is included in the Cable Kit, spare part number

646119-001.

Before removing the optical drive connector cable, follow these steps:

1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the

computer on, and then shut it down through the operating system.

2. Disconnect all external devices connected to the computer.

3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet

and then unplugging the AC adapter from the computer.

4. Remove the battery (see

Battery on page 35), and then remove the following components:

●

Optical drive (see

Optical drive on page 36)

●

Keyboard (see

Keyboard on page 45)

●

Top cover (see

Top cover on page 48)

Remove the optical drive connector cable:

1. Release the optical drive cable from the clips (1) built into the base enclosure.

2. Remove the two Phillips PM2.0×5.0 screws (2) that secure the optical drive connector to the

base enclosure.

3. Remove the optical drive connector (3) from the base enclosure.

Reverse this procedure to install the optical drive connector cable.

Component replacement procedures

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 111 112

No comments

HP Net PC 20 Technical Information Page 67