Hp C737990900 User Manual download pdf (Page 88)

88 Commands

DLM Disable Loop Master. The drive will never attempt to be a loop master.

0 The target may become loop master during the loop initialization process.

1 The target does not become loop master. It only repeats LISM frames it receives. This allows

the initiator to be loop master during loop initialization.

RHA Require Hard Address

0 The target follows the normal initialization procedure, including the possibility of obtaining

a soft address during the loop initialization process.

1 The target only attempts to obtain its hard address available in the SCA connector or device

address jumpers during loop initialization. The target does not attempt to obtain an address

during the LISA phase of initialization.

ALWLI Allow Login Without Loop Initialization

0 The target is required to verify its address through the loop initialization process before a

1 The target uses the hard address available in the SCA connector or device address jumpers

and accept logins without verifying the address with loop initialization.

DTIPE Disable Target Initiated Port Enable

0 The target enables its port into the loop without waiting for a Loop Port Enable primitive.

1 The target waits for an initiator to send the Loop Port Enable primitive before inserting itself

into the loop. The target uses the hard address available in the SCA connector or device

address jumpers to determine if primitives are addressed to it. A Loop Port Enable primitive

with the broadcast address also causes the target to insert itself into the loop.

DTOLI Disable Target Originated Loop Initialization

0 The target generates the Initializing LIP after it enables a port into a loop.

1 The target does not generate the Initializing LIP following insertion into the loop. The target

will respond to an Initializing LIP when it is received. The target generates the Loop Failure

LIP if it detects loop failure at its input and the Initializing LIP when the loop failure is

corrected.

RR TOV Unit Resource Recovery Time-Out Value Unit. The field specifies the unit of measure as follows:

0 No timer specified

11 ms

3100 ms

5 10000 ms

Resource

Recovery

Time-Out Value

The value cannot be changed through

MODE SELECT, but may change as a result of Fabric Login,

FLOGI, which changes the E_D_TOV on which this timer is based.

1 ... 87 88 89 ... 174

No comments

Hp C737990900 User Manual Page 88