Hp Insight Control User Manual download pdf (Page 152)

Insight Control server migration Boot CD might stop responding when exiting the

Array Configuration Utility

When exiting the Array Configuration Utility, the Insight Control server migration Boot CD might stop

responding. If this occurs, to restart the server, physically restart the server or use the Virtual power option

in remote management.

Some storage volumes on the destination server are not available for selection

Some storage volumes configured on the destination server might not be available for selection in Step 5

(Specify Destination Disks and Resize NTFS Partitions) of the Migration Wizard. If expected volumes do not

appear, perform one of the following:

• Verify that the storage controller is supported by Insight Control. Volumes configured on an unsupported

storage controller cannot be selected for migration. For more information about supported controllers,

see the

Insight Control Support Matrix.

• Run the Array Configuration Utility (if your storage controller is supported), and verify the status of the

volumes on the Smart Array controller to be sure that the volumes are not in a failed state. Also, verify

that all volumes on the controller are numbered sequentially beginning with logical drive 1, as required

by the Insight Control. If volumes are not numbered sequentially, clear the configuration and re-create

the necessary volumes.

Static IP address cannot be assigned on the destination server while booting using

the Boot CD

Assigning a static IP address on the destination server might result in an error similar to the following:

The IP address xxx.xxx.xxx.xxx you have entered for this network adapter is

already assigned to another adapter.

This might occur if the IP address is assigned to another network adapter on the destination server. To resolve

this issue, assign a different IP address to the network adaptor or reboot the server.

Supported storage controllers display Unknown on the Boot CD

If the supported storage controllers for P2P or V2P migrations are blocked by the Insight Control server

migration Boot CD, the controller might appear as Unknown.

To correct this issue, reset NVRAM on the destination server:

1. Reboot destination server.

2. To enter ROM-Based Setup Utility (RBSU) during reboot, press F9.

3. Open Advanced Options, and then select Restore Settings/Erase Boot Disk or Clear NVRAM.

4. Reboot the system using the Insight Control server migration Boot CD. The proper storage controller

name is detected.

Auto booting destination server using Insight Control remote management fails

If the destination server does not boot and no error message appears on the application station, then reset

remote management on the destination server, and reboot again.

Insight Control might not detect virtual machines on mapped network drives

Insight Control cannot locate virtual machines stored on mapped network drives if the service does not have

access to the network shares. You must manually migrate these disks after a successful migration.

Destination server boots from the Insight Control server migration Boot CD on a

manual boot

During the migration, when the auto boot option is chosen to boot the destination server, the application

station boots the destination server from the Insight Control server migration Boot CD by connecting the

virtual media to the destination remote management. When the migration is canceled by closing the migration

wizard, the virtual media remains connected to the destination remote management.

152 Troubleshooting

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 172 173

Comments to this Manuals

No comments

Hp Insight Control User Manual Page 152

Comments to this Manuals

Related products and manuals for Tools Hp Insight Control