Hp Insight Control User Manual download pdf (Page 48)

HP Insight Control server migration has detected that this version of

the Linux kernel is not a supported configuration. Please verify that

the configuration is supported in the server migration support matrix.

Suggested action

No action required as RHEL 6.3 is supported in this release. You can proceed with the migration.

The name of HP Ethernet 1Gb 4-port 331i-SPI Adapter is not displayed correctly

When X2P migration is initiated to HP ProLiant DL 580 G7 configured with HP Ethernet 1Gb 4-port

331i-SPI Adapter and when you manually boot the destination server with HP Insight Control server

migration ProLiant Boot CD, the NIC name is not shown correctly under System Information and

Network Configuration page. The name is displayed as Broadcom Corporation, Unknown

device instead of HP Ethernet 1Gb 4-port 331i-SPI Adapter.

Suggested action

No action required.

Source preparation

Corrective action is required before this server can be migrated

The following message appears when an affected system is detected during the launch of the

source server agent:

ATTENTION:Corrective action is required before this server can be

migrated.

Cause

Some versions of Windows Server 2003 that are preinstalled by HP cannot be migrated successfully

unless you perform corrective action before attempting the migration. The server migration Source

Agent detects affected systems during initialization. If the system is affected, instructions for

performing the corrective action are provided. If you attempt the migration without first performing

the corrective action, your destination server becomes nonbootable.

NOTE: The server migration Source Agent will not detect whether the corrective action has already

been performed. Subsequent attempts to execute this agent will indicate that corrective action is

still required. However, the corrective action must be applied only once.

Suggested action

Perform the following:

1. Cancel execution of the migration agent.

2. In the command prompt window, change to the root directory of the Windows disk.

3. Run the following command: SFC/SCANNOW. This command might take several minutes. For

more information about this command, see the following website:

http://support.microsoft.com/kb/310747/en-us

Source server identification fails

The source server identification fails during the first step of the migration wizard.

48 Troubleshooting

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 81 82

No comments

Hp Insight Control User Manual Page 48