HP INTEGRITY RX3600 User Manual download pdf (Page 252)

Figure 6-36 Interconnect Board Removal and Replacement

Interconnect Board Handle

Connector to Display Board

Connector to SAS Backplane Board

Connector to

Midplane Board

Replacing the Interconnect Board

To replace the interconnect board, follow these steps:

CAUTION: Handle the interconnect board carefully, or you can damage the plastic insulator

material on the back of the board.

NOTE: Use the guide posts located on the chassis and keyways located on the interconnect

board to help you with the interconnect board removal and replacement procedures.

1. Place the interconnect board onto the guide posts.

2. Insert your fingers into the board handle and push the board toward the rear of the chassis

until it plugs into the socket on the midplane board (Figure 6-36).

3. Replace the SAS backplane. See “Replacing the SAS Backplane Board” (page 249).

4. Guide the interconnect board air baffle into the chassis and snap it into place (Figure 6-35).

CAUTION: When reconnecting the SAS cables, note the labeling on the channel cables.

Both cables and sockets are clearly marked with the correct channel.Match each cable with

the appropriate socket on the SAS core I/O card. If the cables are mismatched, the server

operating system may not reboot.

5. Reconnect the SAS data and power cables into the connectors on the SAS backplane

(Figure 6-34).

6. Replace the display board. See “Replacing the Display Board” (page 245).

7. Replace the SAS disk drives. See “Replacing a Hot-Pluggable Disk Drive” (page 190).

252 Removing and Replacing Server Components

1 2 ... 247 248 249 250 251 252 253 254 255 256 257 ... 355 356

No comments

HP INTEGRITY RX3600 User Manual Page 252