HP ProLiant Smart Array E200 Specifications download pdf (Page 25)

Removal and replacement procedures 25

3. Remove the server blade.

4. Place the server blade on a flat, level work surface.

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the

internal system components to cool before touching them.

CAUTION: To prevent damage to electrical components, properly ground the server blade

before beginning any installation procedure. Improper grounding can cause ESD.

Access panel

To remove the component:

1. Power down the server blade (on page 24).

2. Remove the server blade (on page 24).

3. Lift the access panel latch and slide the access panel to the rear.

4. Remove the access panel.

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the

internal system components to cool before touching them.

CAUTION: To prevent damage to electrical components, properly ground the server blade

before beginning any installation procedure. Improper grounding can cause ESD.

To replace the component:

1. Place the access panel on top of the server blade with the hood latch open. Allow the panel to

extend past the rear of the server blade approximately 0.8 cm (0.2 in).

2. Engage the anchoring pin with the corresponding hole in the latch.

3. Push down on the hood latch. The access panel slides to a closed position.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 64 65

No comments

HP ProLiant Smart Array E200 Specifications Page 25