HP 1200S Installation Guide download pdf (Page 30)

30 NAS 1200s Installation Guide

2. Go to the NAS device and power it on. It will be several

minutes before the NAS device is accessible on the network.

Note: The NAS device will respond when the NAS operating system

has started.

3. Open Internet Explorer on the PC. Enter https://, the

serial number of the NAS 1200s followed by a hyphen (-),

and then

:3202. Press Enter.

Example:

https://D4059ABC3433-:3202

Note: Substitute the server name for the serial number if a server

name was previously set.

4. Login to the WebUI. This launches the WebUI configuration

application (Rapid Startup) on the target HP StorageWorks

NAS device, as shown in Figure 6.

Note: The default login for the WebUI is administrator and the

password is hpinvent. The WebUI uses the same login as the local

administrator's account or an account with administrative privileges.

5. Go to the next section, “Rapid Startup Wizard

Configuration,” to complete the setup procedures.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 47 48

No comments

HP 1200S Installation Guide Page 30