HP 1200S Installation Guide download pdf (Page 31)

NAS 1200s Installation Guide 31

Direct Attach Method

You can access the WebUI using a monitor, mouse, and keyboard

directly attached to the NAS 1200s.

Procedure

To initialize the NAS 1200s:

1. Connect the Ethernet cables to the respective network ports

of the NAS 1200s and the corresponding network segments.

2. Connect the monitor, mouse, and keyboard directly to the rear

panel connectors of the NAS 1200s. See Figure 2 and Table 2

on page 19 for the locations of the connectors on the NAS

1200s.

3. Open Internet Explorer to launch the WebUI configuration

application (Rapid Startup) on the target StorageWorks NAS

device, as shown in Figure 6. If the WebUI does not launch

connect to the LocalHost and login to the WebUI.

Note: The default login for the WebUI is administrator and the

password is hpinvent. The WebUI uses the same login as the local

administrator's account or an account with administrative privileges.

4. Go to the “Rapid Startup Wizard Configuration” on page 32

to complete the setup procedures.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 47 48

No comments

HP 1200S Installation Guide Page 31