HP D2D2502i User's Guide download pdf (Page 70)

net set wizard

NOTE: This command applies to single-node products only.

Description of Command Function

Runs a step-based wizard to guide you through the creation of a complete network configuration.

Command Syntax

net set wizard

Command Authority

Administrator

Command Object Requirements

Not applicable – no objects exist within this command.

Command Parameter Requirements

Not applicable – no parameters exist within this command.

Requirements for Command Execution

The command entry must conform to the command syntax.

Successful Command Output

Upon successful completion of the command, you will be guided through a set of steps to configure

the network configuration. Upon completion, the command will return:

You have successfully configured the network settings on your StoreOnce

Appliance.

Command Operation during Abnormal Conditions

If the command does not conform to the required syntax, the following is displayed:

Command Failed - the command does not conform to the required syntax,

SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this

section.

Example

# net set wizard

StoreOnce Network Configuration Wizard

--------------------------------------

This Wizard will guide you through the configuration of

network settings on your StoreOnce Backup System

If you wish to make additions or modifications to an existing

network configuration without having to reconfigure all settings

then use the 'net modify' or 'net add' CLI commands instead

The wizard consists of the following steps:

Step 1.) Set system wide DNS server addresses

Step 2.) Configure network settings for available network adapters

Step 3.) Save and apply all network settings

Press ESC+ENTER at any time to exit wizard

Step 1.)

Enter a list (max 3) of DNS servers separated by commas : (eg 192.168.1.100,192.168.3.100)

192.168.1.100,192.168.3.100

Step Complete. Do you want to :

1.) Go to next step: Step 2.) (default)

2.) Go back to start of present step: Step 1.)

3.) Quit wizard and lose all settings

Step 2.)

Select the type of configuration for this subnet :

1.) Single port (default)

2.) Bonded ports (note ports must be the same speed to bond

70 Alphabetical List of Commands and Details

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 177 178

Comments to this Manuals

No comments

HP D2D2502i User's Guide Page 70

Comments to this Manuals

Related products and manuals for Gateways/controllers HP D2D2502i