HP D2D2502i User's Guide download pdf (Page 31)

hardware enable failover

NOTE: This command applies to multi-node products only.

Description of Command Function

Enables the failover feature between nodes which had been disabled using the hardware

disable failover (see “hardware disable failover” (page 29)) command.

Command Syntax

hardware enable failover [NODEX]

Command Authority

Administrator

Command Object Requirements

NODE

– As an option, this can be used to define an individual file server node. X is a unique

numeric index. NODEX is a label uniquely defining the hardware component. It was assigned

during the initial automatic hardware initialization and configuration and its value resides in the

“node_config” file. A complete list of the NODEX labels can be obtained using the hardware

show node status command (see “hardware show node status” (page 42)). If a file server

node is defined, failover is only enabled for this node.

Command Parameter Requirements

Not applicable – no parameters exist within this command.

Requirements for Command Execution

• The command entry must conform to the command syntax.

• Failover must already be disabled.

Successful Command Output

Upon successful completion of the command, the following is displayed:

failover enabled

Command Operation during Abnormal Conditions

• If the command does not conform to the required syntax the following is displayed:

Command Failed - the command does not conform to the required syntax,

SYNTAX where SYNTAX is the command syntax as described under Command Syntax in this

section.

• If failover is already enabled, the following is displayed:

Command Failed - failover is already enabled.

Example

# hardware enable failover node1

failover enabled

hardware enable failover 31

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 177 178

No comments

HP D2D2502i User's Guide Page 31