HP D2D2502i User's Guide download pdf (Page 115)

Configure Network [execute]?

Please choose a template to apply:

1) Management on (2) 1Gb ports (bonded), Data/Replication on (2) 10Gb ports

(bonded) - Template 1

2) Management/Data/Replication on (4) 1Gb ports (bonded) - Template 2

3) Management/Data/Replication on (2) 10 Gb ports (bonded) - Template 3

4) Management on (2) 1Gb ports (bonded), Data/Replication on (2) 1Gb ports

(bonded) - Template 4

5) Management/Data/Replication on (2) 1Gb ports (bonded) - Template 5

quit) quit without configuring the network

Please select a template (1-5) or "quit":

====================================================================

Template #1 - Management on (2) 1Gb ports (bonded), Data/Replication on (2) 10Gb ports (bonded)

Do you want to configure a 1GbE management and 10GbE data network? [Y/(N)]:

Enter Virtual Management Console IP Address

(must be IPv4 X.X.X.X):

--------------------------------------------------------------------

Select bonding mode for 1GbE management bond

enter 1 (Active/Backup),

4 (IEEE 802.3ad Dynamic Link Aggregation),

or 6 (Active Load Balancing),

(default = 1):

Enter 1GbE management network start IP address

(must be IPv4 X.X.X.X):

An incorrect entry…

Error: The IP Address provided should not lie between the existing

range of network IP addresses. Please enter the value again

Enter 1GbE management network end IP address

(must be IPv4 X.X.X.X):

Enter 1GbE management subnet mask

(must be IPv4 X.X.X.X):

--------------------------------------------------------------------

Select bonding mode for 10GbE data bond

enter 1 (Active/Backup),

4 (IEEE 802.3ad Dynamic Link Aggregation),

or 6 (Active Load Balancing),

(default = 1): 1

Enter 10GbE data network start IP address

(must be IPv4 X.X.X.X):

Enter 10GbE data network end IP address

(must be IPv4 X.X.X.X):

Enter 10GbE data subnet mask

(must be IPv4 X.X.X.X):

Error: Incorrect number of IP address blocks entered.

Please enter the values again

--------------------------------------------------------------------

Select bonding mode for 1GbE management bond

enter 1 (Active/Backup),

4 (IEEE 802.3ad Dynamic Link Aggregation),

or 6 (Active Load Balancing),

(default = 1): 4

Bonding mode 4 (dynamic link aggregation) requires the ports on your network switch(es) to be configured for

LACP. This change must be made immediately after applying the changes in the network configuration on this

system.

This is to maintain reliable network connectivity to this system.

Continue with network setup? [Y/N]:

Enter 1GbE management network start IP address

(must be IPv4 X.X.X.X):

Enter 1GbE management network end IP address

(must be IPv4 X.X.X.X):

Enter 1GbE management subnet mask

system set config 115

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 177 178

Comments to this Manuals

No comments

HP D2D2502i User's Guide Page 115

Comments to this Manuals

Related products and manuals for Gateways/controllers HP D2D2502i