HP D2D2502i User's Guide download pdf (Page 65)

net modify subnet

NOTE: This command applies to single-node products only.

Description of Command Function

Modifies an existing named subnet configuration. Modifies parameters in the current configuration

and validates and activates settings.

NOTE: It is not possible to modify the default configuration.

Command Syntax

net modify subnet <netlabel> <sublabel> [default {yes|no}] [domain

{<string>|DHCP}] [IPAddr {DHCP|address}] [netmask <mask>] [gateway

<gateway>] [ports <list>] [bonding <mode>]

Command Authority

Administrator

Command Object Requirements

• netlabel – This label identifies the network configuration containing the subnet configuration

to be modified. This label is case insensitive.

• sublabel – This label identifies the subnet configuration that will be modified. This label is case

insensitive.

Command Parameter Requirements

• default – This optional parameter defines if the preceding subnet configuration is the default

subnet. The values for this parameter can be either Yes or No.

• domain – This optional parameter defines the domain name for the subnet configuration.

• IPAddr – This parameter defines an IP address. The value DHCP can be used to indicate that

the IP address will be defined by a DHCP server.

• netmask – This optional parameter defines the netmask. If the IPAddr value is DHCP, a value

is not required for netmask.

• gateway – This optional parameter defines the gateway for the subnet configuration.

• ports – This parameter defines the ports which will be attached to the subnet for each node

associated with the network configuration containing the subnet. (See the “net activate config”

(page 55) command for details on how the nodes are associated with network configurations.)

The values consist of a list of integers separated by commas; the integers define the physical

ports on the nodes. Execute the “net show ports” (page 78) command to obtain information

on which integers may be used to define ports for the subnet configuration. The maximum

number of values depends on your system; use the Command Authority (page 56) command

for information on which ports are available.

• bonding – This parameter defines how the multiple ports are bonded. The supported bonding

modes and the default bonding modes for specific templates are shown in the table below.

Note that if only one port is defined, the bonding value should be undefined. See the HP

net modify subnet 65

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 177 178

No comments

HP D2D2502i User's Guide Page 65