HP D2D2502i User's Guide download pdf (Page 55)

net activate config

NOTE: This command applies to single-node products only.

Description of Command Function

Configures the external network.

IMPORTANT: If the network you are using for the CLI session is modified from this command,

your session may be terminated.

Command Syntax

net activate config <netlabel>

Command Authority

Administrator

Command Object Requirements

netlabel – This required object identifies the network configuration whose data structure will be

used to configure the external network for the cluster.

Command Parameter Requirements

Not applicable – no parameters exist within this command.

Requirements for Command Execution

The following list shows some examples but is not a complete list of checks.

• Verify the configuration structure according to the rules below:

A default subnet must exist.◦

◦ Only one default subnet can exists.

◦ A gateway is required for the default subnet.

◦ The ports defined in a subnets must be valid options.

◦ If more than one port is defined in a subnet, all the ports must be the same type.

◦ The same port cannot be in two different subnets or defined twice in same subnet.

• If DHCP is defined in any subnet, verify that the DHCP server exists.

• Configure the external network as defined by the configuration data structure.

• If defined, verify that the gateway exists.

Successful Command Output

Upon successful completion of the command, information on the external network configuration is

displayed.

Command Operation during Abnormal Conditions

If the command fails, the system will attempt to configure the external network using the original,

current configuration.

Example

# net activate config management

net activate config 55

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 177 178

No comments

HP D2D2502i User's Guide Page 55