HP D2D2502i User's Guide download pdf (Page 34)

hardware poweroff

NOTE: This command applies to multi-node products only.

Description of Command Function

Powers down the StoreOnce appliance. If a file server node is defined in the command entry, only

this node is powered down.

NOTE: This command will only work if failover is enabled. See the system enable failover

command, “system enable failover” (page 110)

Command Syntax

hardware poweroff [NODEX]

Command Authority

Administrator

Command Object Requirements

NODE

– As an option, this can be used to define an individual file server node. X is a unique

numeric index. NODEX is a label uniquely defining the hardware component; it was assigned

during the initial automatic hardware initialization and configuration and its value resides in the

“node_config” file. A complete list of the NODEX labels can be obtained using the hardware

show node status command (see “hardware show node status” (page 42)). If a file server

node is defined, only this node is powered down.

Command Parameter Requirements

Not applicable – no parameters exist within this command.

Requirements for Command Execution

• The command entry must conform to the command syntax.

• At least one system with an active CLI must exist.

• If a file serving node is defined in the command entry, the defined node must be powered up.

• This command will only work if failover is enabled.

Successful Command Output

Upon successfully sending the power off request, the following is displayed:

poweroff request successfully sent

NOTE: This message only indicates the success for the shutdown request. The hardware show

node status command (see “hardware show node status” (page 42)) must be entered to verify

the server nodes shutdown correctly. Also, if the shutdown applies to the node currently supporting

the CLI interface, the session will be terminated following this command.

Command Operation during Abnormal Conditions

• If the command does not conform to the required syntax, the following is displayed:

Command Failed - the command does not conform to the required syntax,

SYNTAX where SYNTAX is the command syntax as described under Command Syntax in this

section.

• If the node is already powered down, the following is displayed:

Command Failed – NODEX already shutdown, where NODEX is the file server node

object defined in the command entry.

Example

# hardware poweroff node1

34 Alphabetical List of Commands and Details

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 177 178

Comments to this Manuals

No comments

HP D2D2502i User's Guide Page 34

Comments to this Manuals

Related products and manuals for Gateways/controllers HP D2D2502i