HP D2D2502i User's Guide download pdf (Page 27)

hardware delete storage

NOTE: This command applies to single-node products only.

Description of Command Function

Deletes storage segments associated with the StoreOnce system “backend” file system. This

command does not apply to the storage on which each nodes operating system is located.

Command Syntax

Hardware delete storage {ALL|dev-id}

Command Authority

Administrator

Command Object Requirements

Not applicable – no objects exist within this command.

Command Parameter Requirements

• ALL – When this global parameter is defined in the command sequence, all couplet file systems,

logical segments, logical volumes, and physical volume are removed. The system is left in a

state in which no storage is configured. The command requires this parameter or a dev-id

value.

• dev-id – This parameter defines a specific volume to be deleted. A specific volume is defined

as a storage component with a specific SCSI LUN. The device ID for the storage component

to be deleted can be determined using the hardware show status command. The

command requires this parameter or the global ALL.

Requirements for Command Execution

• The command entry must conform to the command syntax.

• All parameter values must be valid; see the parameter descriptions for details.

Successful Command Output

Prior to executing the command the following message is displayed:

Warning – Data may be destroyed. Are you sure you want to delete storage?

y / n

You must enter a y response for command execution to continue. Upon successful completion of

the command, the following is displayed:

Command Successful

Command Operation during Abnormal Conditions

• If any of the command execution requirements fail, command execution terminates. The beacon

status is unchanged and one of these error messages is displayed:

◦ Command Failed - the command does not conform to the required

syntax, SYNTAX, where SYNTAX is the command syntax as described under Command

Syntax in this section.

◦ Command Failed – The global parameter ALL or a device ID must be

defined

◦ Command Failed – The device ID is not a storage volume

◦ Command Failed – The device does not exist

hardware delete storage 27

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 177 178

No comments

HP D2D2502i User's Guide Page 27