HP D2D2502i User's Guide download pdf (Page 109)

system disable failover

NOTE: This command applies to multi-node products only.

Description of Command Function

Disables the failover feature on the StoreOnce appliance. It is a direct map to the command

sequence hardware disable failover (see “hardware disable failover” (page 29)). For the

initial release, this command will only disable failover for the entire appliance. In following releases,

the command will be updated to disable failover for given service sets.

Command Syntax

system disable failover

Command Authority

Administrator

Command Object Requirements

Not applicable – no objects exist within this command.

Command Parameter Requirements

Not applicable – no parameters exist within this command.

Requirements for Command Execution

• The command entry must conform to the command syntax.

• Failover must not already be disabled.

Successful Command Output

Upon successful completion of the command, the following is displayed:

failover disabled

Command Operation during Abnormal Conditions

• If the command does not conform to the required syntax, the following is displayed:

Command Failed - the command does not conform to the required syntax,

SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this

section.

• If failover is already disabled for all nodes, the following is displayed:

Command Failed - failover is already disabled

Example

# system disable failover

failover disabled

system disable failover 109

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 177 178

No comments

HP D2D2502i User's Guide Page 109