Hp Media Center PC User Manual download pdf (Page 25)

Connecting the Television Signal 21

Connecting the Remote Sensor

The remote sensor is a small device that connects to

the PC and allows the remote control to work with

the Media Center program.

1 If you have a cable TV set-top box, a satellite

set-top box, or other set-top box that controls

your TV signal, connect the remote control

sensor cable (emitter) (A) into connector (1)

on the back of the remote sensor; otherwise

skip to step 3. Connector (2) can also be used

if you have a second set-top box.

2 Remove the paper from the backing tape on

the end of the cable (B), and then press the

end of the cable over the remote infrared (IR)

receiver window on your cable TV set-top

box (C). You can locate the remote infrared

receiver window by using a flashlight to shine

through the plastic on the front of most

devices.

3 Plug the remote control sensor cable into a

USB connector (D) on the back of the PC.

4 Place the remote sensor so that you can easily

point at it with the remote control. (An ideal

spot would be on top of the monitor or desk.)

You can locate the

remote infrared

receiver window on

your cable TV set-top

box by using a

flashlight to shine

through the plastic on

the front of most

devices.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 85 86

No comments

Hp Media Center PC User Manual Page 25