Hp Lights-Out 100 Remote Management User Manual download pdf (Page 36)

Using LO 100 36

4. In the Storage Type dropdown list, select the storage type that matches the selected resource and

click Select.

You must have valid media in the drive if a removable media device type is selected. The selected

device displays in the dialog box.

5. Select the device and click Connect. A message box appears, indicating either the device has been

successfully connected or a problem has occurred.

6. Click OK to close the Storage Device window.

To remove a shared virtual media device, do the following:

Before removing a shared device, verify the device is safe to remove. If necessary, perform any required

steps necessary to ensure the safe removal of removable media devices on the server.

1. On the Virtual KVM menu, select Storage. The Storage Devices window appears, displaying all

previously added devices currently available.

2. Select the device you want to remove and click Remove. A dialog box appears, indicating that the

device has been successfully disconnected.

3. Click OK to close the Storage Device window.

Accessing the remote console through telnet

You can access the remote console through either the BIOS console text-redirection functionality or a

Microsoft® Windows Server™ 2003 text-based console. Only one Remote Console window can be open

at a time.

To start a remote console session, press the Esc+Q keys. To end a remote console session and return to the

CLP press the Esc+( keys.

Redirecting BIOS console text through telnet

LO 100 BIOS console text redirection enables you to view the entire boot process remotely and make

changes in the BIOS Setup Utility from a remote computer. This tool is valuable in troubleshooting and

managing servers remotely.

To configure the BIOS Setup Utility on the target system:

1. Press the F10 key during POST to enter the BIOS Setup Utility.

2. Press the right arrow (→) key to navigate to the Advanced menu.

3. Press the down arrow (↓) key to scroll down to the Remote Access Configuration option, and press

the Enter key. Verify the following settings:

o Remote Access—Enabled

o EMS Support (SPCR)—Enabled

4. Press the Esc key to return to the previous screen.

5. Scroll to the I/O Device Configuration option, and press the Enter key.

6. Verify that Serial Port is set to Shared.

7. Follow the instructions in the "Network settings (on page 41)" section to set or obtain a valid IP

address.

8. Press the F10 key to save and exit.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 51 52

No comments

Hp Lights-Out 100 Remote Management User Manual Page 36