Hp Lights-Out 100 Remote Management User Manual download pdf (Page 21)

Using LO 100 21

target address. In a remote management processor implementation, the firmware downloads a full

image file using TFTP from the specified location and programs flash with the image.

In a remote management processor implementation, /map1/firmware is a valid target.

The load command supports usage only with the following options.

o -source <location>—This option must be specified.

o (h)elp—This option appears on the command line, the command ignores all options and

properties except -output (for terse or verbose output). These options are only valid for this

command when the -help option is used.

o source <value>—This option specifies the target from which it transfers the binary image. The

value specified must be a valid URL. The format is //tftpserverip/path/filename. This

option is required in the command line every time the load command is executed unless -help

is used. The file must be an uncompressed firmware image file that you create using the DOS

ROMPAQ utility found on the Lights-Out 100 Firmware Upgrade Diskette Utility available for

download from the HP website (http://www.hp.com/servers/lights-out

To create the uncompressed image file, enter the following command from DOS:

ROMPAQ /D <infile> <outfile>

where <infile> is the ROMPAQ firmware image file and <outfile> is the filename for the

uncompressed binary image file.

The load command returns any status data on the first lines. After the status data appears, one of

the following lines of text displays on the next line:

— <URL> transferred to <target address> (if the file is transferred)

— <URL> not transferred (if the file is not transferred)

Example:

load -source //192.168.2.1/pub/firmwareimage.bin -oemhpfiletype csr

//192.168.2.1/pub/firmwareimage.bin transferred to

/map1/firmware/fullimage

• The reset command causes a target to cycle from enabled to disabled and back to enabled.

• The set command assigns a specific value to a property or group of properties. The standard

syntax for the set command is set property = new value.

The set command is used to change any changeable property. If the current directory does not

contain the property you want to change, the target of the property must be specified before entering

the property you want to change.

• The start command causes a target to change state to a higher run level.

• The stop command causes a target to change state to a lower run level.

• The version command queries the version of the CLP implementation or other CLP elements. For

example:

/./map1/-> version

Version 1.00

/./map1/-> cd firmware

/./map1/firmware/-> version

Version 1.00

/./map1/firmware/-> show

/./map1/firmware

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 51 52

Comments to this Manuals

No comments

Hp Lights-Out 100 Remote Management User Manual Page 21

Comments to this Manuals

Related products and manuals for Computer Accessories Hp Lights-Out 100 Remote Management