Hp Virtual Connect 1.10Gb-F Ethernet Module for c-Cla User Manual

HP BladeSystem c-Class Virtual Connect Support Utility Version 1.3.0 User Guide Part Number 495235-001 June 2008 (First Edition)

Commands 10 o Module Configuration: In Sync, Not In Sync, Invalid o Domain Configuration (for primary or backup VC-Enet modules): In Sync, Not In Sy

Commands 11 report Display the current running firmware version on all modules in a specific target enclosure, plus display the VC-Enet and VC-FC fir

Commands 12 supportdump Log into VC Manager using the supplied credentials and access Virtual Connect to request a support information (debug dump) d

Commands 13 Item Description VCM USER Name of Virtual Connect user with Domain privileges. Required if an enclosure is in a Virtual Connect domain. V

Commands 14 version Display the current running firmware version on all modules in a specific target enclosure. Item Description Syntax vcutil -a ve

Troubleshooting 15 Troubleshooting Error messages Error message Resolution This version of the application does not support the target enclosure Sp

Troubleshooting 16 Error message Resolution Unable to get enclosure VC mode information Log into VC Manager GUI and resolve any errors with VC Mana

Technical support 17 Technical support Before you contact HP Be sure to have the following information available before you call HP: • Technical su

Acronyms and abbreviations 18 Acronyms and abbreviations CLI Command Line Interface DHCP Dynamic Host Configuration Protocol DNS domain name syste

© Copyright 2008 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. The only warranties

Contents 3 Contents Introduction...

Introduction 4 Introduction Overview The HP BladeSystem c-Class Virtual Connect Support Utility enables administrators to upgrade VC-Enet and VC-FC f

Introduction 5 • Onboard Administrator firmware 1.30 or higher is required on the target enclosure. OA firmware version 2.20 is recommended. • Only

Introduction 6 Usage Use the following steps to install and run the HP BladeSystem c-Class Virtual Connect Support Utility. 1. Install the applicati

Introduction 7 OA Password :*********** Confirm Password :***********

Commands 8 Commands collect Contact the OA using the supplied credentials and execute a SHOW ALL from the OA CLI, saving the output to an "oaSho

Commands 9 Item Description Syntax vcutil -a discover -s <START IP> -e <END IP> Parameters: START IP First IP address in the range to