Hp Virtual Connect 1.10Gb-F Ethernet Module for c-Cla User Manual

HP BladeSystem c-Class Virtual Connect Support Utility User Guide Version 1.2.0 Part Number 482172-001 February 2008 (First Edition)

Troubleshooting 10 Troubleshooting Error messages Error message Resolution This version of the application does not support the target enclosure Sp

Troubleshooting 11 Error message Resolution Unable to get enclosure VC mode information Log into VC Manager GUI and resolve any errors with VC Manag

Technical support 12 Technical support Before you contact HP Be sure to have the following information available before you call HP: • Technical sup

Acronyms and abbreviations 13 Acronyms and abbreviations CLI Command Line Interface DHCP Dynamic Host Configuration Protocol DNS domain name syste

© Copyright 2008 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. The only warranties

Contents 3 Contents Introduction...

Introduction 4 Introduction Overview The HP BladeSystem c-Class Virtual Connect Support Utility enables administrators to upgrade VC-Enet and VC-FC m

Introduction 5 Command line syntax CLI input is case-insensitive except when otherwise noted. The general CLI syntax format is as follows: vcutil -a

Introduction 6 Non-VC modules are shown as “Unknown or unsupported module.” Detailed information is displayed for supported VC modules only. 6. Enter

Commands 7 Commands version Display the current running firmware version on all modules in a specific target enclosure. Item Description Syntax vcut

Commands 8 Examples Display all modules in an enclosure: vcutil -a report -i 192.168.1.100 -u Administrator -p password -l VCpackage Display a single

Commands 9 Item Description BAY Optional. The bay number of the target module. If not specified, the default is all supported modules. -f version Opt