HP NC552SFP 10Gb 2-port Ethernet Server Adapter User Guide Abstract This document is for the person who installs, administers, and troubleshoots se
Specifications 10 Specifications Cable specifications SFP+ module type Cable Connector Type Wavelength (nm), type of cable Core Size (microns, µm)
Specifications 11 General specifications Specification Value Controller Emulex BladeEngine 3 (BE3) Data rate 20Gb/s, full-duplex PCI bus 8 Lane
Regulatory compliance notices 12 Regulatory compliance notices Safety and regulatory compliance For safety, environmental, and regulatory informatio
Electrostatic discharge 13 Electrostatic discharge Preventing electrostatic discharge To prevent damaging the system, be aware of the precautions yo
Acronyms and abbreviations 14 Acronyms and abbreviations CE Conformité Européenne (European Conformity) CSA Canadian Standards Association DAC dir
Acronyms and abbreviations 15 UL Underwriters Laboratory
Documentation feedback 16 Documentation feedback HP is committed to providing documentation that meets your needs. To help us improve the documentat
© Copyright 2011, 2013 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. The only war
Contents 3 Contents Technician notes ...
Technician notes 4 Technician notes Warnings, cautions, and notes WARNING: Only authorized technicians trained by HP should attempt to repair th
Technician notes 5 2. Select Support & Drivers, and then select Drivers & Downloads. 3. Type the adapter name in the Find by product box, a
Introduction 6 Introduction Overview The HP NC552SFP 10Gb 2-port Ethernet Server Adapter is a dual port 10GbE adapter for ProLiant DL, ML, and SL pl
Installing an adapter 7 Installing an adapter Installation overview This section describes installation precautions, how to install the adapter, and
Installing an adapter 8 Installing an adapter in a server See the HP ProLiant server documentation for additional information on how to safely insta
Installing an adapter 9 1. Using a correctly sized Phillips head screwdriver, carefully remove the two board lock screws located above and below the
Comments to this Manuals