HP ew2500 Installation Manual download pdf (Page 11)

Test button functions

The test button, which is located on the back of the HP Jetdirect ew2500 print server, provides various

functions depending on the number of the times the button is pressed. These functions can be useful

during the installation process.

NOTE: Typically, you press the button the indicated number of times in quick succession. However,

some options provide additional functionality when holding the last button press.

Table 1-1 Test button instructions

Button Presses Function Instructions and Status Light (if applicable)

1 Print an HP Jetdirect configuration

page.

Changes to blinking green for approximately five seconds.

2 Print an HP Jetdirect security page.

3 Print an HP Jetdirect configuration

page in English, French, Italian,

German, or Spanish.

On the third press, hold the button down until the status light begins

blinking, and then release the button. The configuration page prints

in all languages.

4 Print an HP Jetdirect wireless status

page.

5 Change the LAN speed/handshake.

This is only for switches that do not

have auto negotiation mode set,

Select from the following speeds/

handshake: 10 Mbps. half-duplex, 10

Mbps. full-duplex, 100 Mbps. half-

duplex, or 100 Mbps. full-duplex.

On the fifth press, hold the button down until the status light begins

blinking, then release the button.

Select from the following speed/handshake combinations (displayed

three times):

●

Blinking amber — 10 half-duplex

●

Solid amber — 10 full-duplex

●

Blinking green — 100 half-duplex

●

Solid green — 100 full-duplex

To select a speed/handshake:

1. Press and release the test button when the color associated with

the speed/handshake you want is displayed. (The test button

turns off then displays the selected color.)

2. If the speed is correct (indicated by the test button color), press

and release the test button once to confirm.

3. If the speed/handshake is not correct (indicated by the test

button color), do not press the test button. The change is not

made. You can then start over and change the speed/

handshake.

4. To complete (save) the change, power cycle the print server.

6 Reset 802.1x to factory default

values.

To complete (save) the change, power cycle the print server.

7 Disable IPsec. To complete (save) the change, power cycle the print server.

ENWW Test button functions 3

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 57 58

Comments to this Manuals

No comments

HP ew2500 Installation Manual Page 11

Comments to this Manuals

Related products and manuals for WLAN access points HP ew2500