HP B1000 User Manual download pdf (Page 143)

Chapter 4 143

Field Replaceable Units

FRU Removal and Replacement

Figure 4-57. Installing Memory Cards

7. Place the DIMM card in the connector, lining it up with the guides. Make sure to put

the notched end toward the white ejector tab (to the left). See Figure 4-57.

8. Close the ejector tab.

9. Press ﬁrmly and evenly on the DIMM card to ensure that it seats properly. The ejector

tabs engage when the DIMM is properly seated.

10.Replace the power supply and workstation left side panel. You may now plug the power

cord back in to the electrical outlet.

11.Verify that this installation was successful by following the steps in Chapter 6, “The

Boot Console Handler.” If you have only replaced a faulty DIMM, you must execute the

pdt clear command in the service menu of the Boot Console Handler. Answer yes (Y)

to the prompt “Continue? (Y/N) >.”

Once you have completed the steps listed above, the DIMM cards are properly loaded.

Removing Memory

Perform the following steps to remove memory (DIMM cards) from the system unit.

1. Open the side panel of the system unit as explained in the section “Opening the Left

Side Panel of the System Unit” in this chapter.

2. Lay the system on its side as shown in Figure 4-58.

Press down on ejector tabs to open

them and place the DIMM card in

the connector so that your ﬁngers

are on the edge of the DIMM card.

Push the DIMM card down ﬁrmly

and evenly into the connector to

be sure it is properly seated.

White Ejector Tab

Black

Ejector Tab

Notches

Step 1

Step 2

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 238 239

No comments

HP B1000 User Manual Page 143