HP R2200 User Manual download pdf (Page 11)

Component identification 11

To restore power to the load devices after the REPO feature is activated, press the Power On/Standby

button after the AC source is reconnected to the UPS.

IMPORTANT: Pressing and holding the Power On/Standby button without utility present normally initiates

a battery start and the UPS assumes the load. However, if the Power On/Standby button is pressed and a

REPO is detected, battery start is inhibited and the UPS is not able to assume the load.

To power down the entire network in the event of an emergency, the REPO ports of multiple UPS units can

be connected to a single switch.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 60 61

No comments

HP R2200 User Manual Page 11