Hp Secure Key Manager User Manual Page 204

  • Download
  • Add to my manuals
  • Print
  • Page
    / 352
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 203
This configuration is the same as example 3, but in this scenario there are some hosts and networks
that are not reachable through 172.17.7.1. Most often these would be private or secure sub-networks.
In such a case you would add a static route out of 10.20.41.1 so that the SKM appliance can reach
the additional hosts or networks. The static route is shown here:
InterfaceGatewaySubnet MaskIP Address
-----------------------------------------------------------------
Ethernet #210.20.41.1255.255.255.066.230.200.0
Static Route List
The Static Route features allows you to explicitly specify a route from the SKM to another network
device. Such a route is stored in the routing table on the SKM.
Figure 112 Viewing the Static Route List section
The following table describes the components of the Static Route List section.
Table 93 Static Route List section components
DescriptionComponent
The address that you are trying to reach with this route. Valid values are IP or network
addresses matching the specified Subnet Mask.
IP Address
The network mask associated with the IP Address/Network needed to identify the
destination. Valid values are any subnet mask address.
Subnet Mask
The gateway used to reach the destination. A static route that does exclude a gateway
indicates that the destination address can be reached on the local subnet for the spe-
cified physical interface. Values for the Gateway field are constrained by the following:
If you specify a value for the Gateway field, you must specify an IP address.
The gateway must be reachable based on the network routes created by the addition
of an IP address to the system.
The gateway address cannot be a broadcast or network address as determined
by the IP addresses on the system or the static route being added.
The gateway must not be used by any other route on a different physical interface.
Gateway
The physical interface on the SKM used to reach the destination.Interface
Click Edit to modify the static route list.Edit
Click Add to add a new static route.Add
Click Delete to remove a static route.Delete
Using the Management Console204
Page view 203
1 2 ... 199 200 201 202 203 204 205 206 207 208 209 ... 351 352

Comments to this Manuals

No comments