Hp Secure Key Manager User Manual download pdf (Page 144)

Figure 69 Viewing the User List section

The following table describes the components of the User List section.

Table 50 User List section components

DescriptionComponent

Displays the users in the group.Username

Click Add to add a user to the user list.Add

Click Delete to delete a user from the user list.Delete

LDAP Server Configuration

Lightweight Directory Access Protocol (LDAP) is a protocol that allows you to enable authentication

of your KMS Server based on a central directory of users, rather than the local users and groups

defined on each device. To use LDAP with the KMS Server, you need an LDAP server available such

as MS Active Directory, Netscape Directory Server or OpenLDAP. You should also be familiar with

the schema defined by that server.

NOTE:

If you set up the KMS Server to use LDAP for users and groups, those users and groups are

case-

sensitive. For example, a user ID of JohnSmith can also be used throughout the system as

johnsmith. This is different from most other parts of the system where upper and lower case are treated

differently.

Passwords for both local users and LDAP users must not contain the less than character (<).

The LDAP Server Configuration page of the Management Console describes the configuration of the

LDAP server and its schema.

This page contains the following sections:

• LDAP User Directory Properties

• LDAP Schema Properties

• LDAP Failover Server Properties

LDAP User Directory Properties

Use the LDAP User Directory Properties section to define the basic properties of the LDAP server.

Using the Management Console144

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 351 352

No comments

Hp Secure Key Manager User Manual Page 144