Hp LaserJet 4050 Printer series User Manual Page 154

  • Download
  • Add to my manuals
  • Print
  • Page
    / 260
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 153
132 Chapter 4: Problem Solving
EN
If the print server failed to link, verify that all cables are correctly
connected. If all cables are correctly connected and the print server
still fails to link, follow the steps below to reconfigure the print server:
1 Turn off the printer and remove the HP JetDirect 10/100TX print
server.
2 Use jumpers P1, P2, and P3 to manually configure the print
server for either 10 or 100 Mbps (megabits per second) link
speed, and Full- or Half-duplex operation according to the table
below:
3 Reinstall the print server.
4 Verify that the configuration of the connecting network device
(such as a 10/100TX network switch) matches. For example, to
set the print server for 100TX Full-duplex operation, the port on
the network switch must also be set for 100TX Full-duplex
operation.
5 Turn the printer off and back on and check the print server
operation. If the print server fails to link, contact a local
HP-authorized dealer or service representative.
Print Server Operation Jumper P1 Jumper P2 Jumper P3
Autonegotiation Enabled AUTO
100 Half-duplex (not AUTO) 100 H
100 Full-duplex (not AUTO) 100 (not H)
10 Half-duplex (not AUTO) (not 100) H
10 Full-duplex (not AUTO) (not 100) (not H)
Page view 153
1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 259 260

Comments to this Manuals

No comments