HP ZBook 15 G3 Base Model Mobile Workstation User Manual download pdf (Page 166)

Connector types

IMPORTANT: Connector pins and connector gold ngers should not be touched directly with bare hands.

There are several dierent types of connectors on the system board with dierent requirements for cable

removal or insertion.

Flex cable

When connecting ex cables, push the cable completely, evenly into the connector.

When removing ex cables from a ZIF connector on the system board, always follow these steps:

1. Squeeze on the top of the retaining latch attached to the cable end of the connector.

2. Grasp the cable end of the connector and pull it straight out.

CAUTION: Always release connector latch before removing the cable. Otherwise, pulling the cable could

damage the cable pins and result in a failed device.

Horizontal installation cable

Use at tool to pull connector evenly. Do not pull on cable to remove.

Slide connector into receptacle on same horizontal plane as board and use at tool to push evenly into

receptacle.

154 Chapter 7 Troubleshooting guide

1 2 ... 161 162 163 164 165 166 167 168 169 170 171 ... 206 207

No comments

HP ZBook 15 G3 Base Model Mobile Workstation User Manual Page 166