HP 165st User's Guide download pdf (Page 29)

2-13

Upgrading Drives and Capacity in 5.2-Gb Drive Jukeboxes

Upgrading Drives (C1154J/K/L, C1158J/K/L Kits)

3. Slide the bottom drive into the enclosure far enough to connect a set of drive

cables to the drive as shown in #1, #2, and #3 on Figure 2-10.

As you connect the drive interface cable, slide the cable into the cable clip on the

rear of the drive.

4. Slide the top drive into the enclosure far enough to connect a set of drive cables

to the drive as shown in #1, #2, and #3 on Figure 2-10.

As you connect the drive interface cable, slide the cable into the cable clip on the

rear of the drive.

5. Mount the cable clip on the rear of both drives as shown in Figure 2-10.

6. Insert the T-10 screws to mount the drives (see Figure 2-9).

Each drive uses four screws; two on each side.

7. Remount the top and bottom covers on the enclosure (see Figure 2-9)

8. Mount the plastic air seal over the top portion of the cable access hole as shown

in #1 on Figure 2-11.

Mount a small portion of the plastic over the hole on the right side of the

enclosure as shown in #2 on Figure 2-11

Figure 2-11 Applying the Air Seals to the Drive Enclosure

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 85 86

No comments

HP 165st User's Guide Page 29