HP COMPAQ DC5750 Troubleshooting Guide download pdf (Page 57)

Control panel message Description Recommended action

or contact an authorized dealer or reseller for

RTC battery replacement.

163-Time & Date Not Set Invalid time or date in configuration memory.

RTC (real-time clock) battery may need to

be replaced.

Reset the date and time under Control

Panel (Computer Setup can also be used). If

the problem persists, replace the RTC

battery. See the Hardware Reference Guide

on the Documentation and Diagnostics CD

for instructions on installing a new battery, or

contact an authorized dealer or reseller for

RTC battery replacement.

163-Time & Date Not Set CMOS jumper may not be properly installed. Check for proper placement of the CMOS

jumper if applicable.

164-MemorySize Error Memory amount has changed since the last

boot (memory added or removed).

Press the F1 key to save the memory

changes.

164-MemorySize Error Memory configuration incorrect. 1. Run Computer Setup or Windows

utilities.

2. Make sure the memory module(s) are

installed properly.

3. If third-party memory has been added,

test using HP-only memory.

4. Verify proper memory module type.

201-Memory Error RAM failure. 1. Run Computer Setup or Windows

utilities.

2. Ensure memory modules are correctly

installed.

3. Verify proper memory module type.

4. Remove and replace the identified faulty

memory module(s).

5. If the error persists after replacing

memory modules, replace the system

board.

213-Incompatible Memory Module in

Memory Socket(s) X, X, ...

A memory module in memory socket

identified in the error message is missing

critical SPD information, or is incompatible

with the chipset.

1. Verify proper memory module type.

2. Try another memory socket.

3. Replace DIMM with a module

conforming to the SPD standard.

214-DIMM Configuration Warning Populated DIMM Configuration is not

optimized.

Rearrange the DIMMs so that each channel

has the same amount of memory.

219-ECC Memory Module Detected ECC

Modules not supported on this Platform

Recently added memory module(s) support

ECC memory error correction.

1. If additional memory was recently

added, remove it to see if the problem

remains.

2. Check product documentation for

memory support information.

Table A-1 Numeric Codes and Text Messages (continued)

ENWW POST Numeric Codes and Text Messages 51

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 71 72

Comments to this Manuals

No comments

HP COMPAQ DC5750 Troubleshooting Guide Page 57

Comments to this Manuals